Differences

This shows you the differences between two versions of the page.

--- home:rf_control [2021/01/31 20:05]
derek
+++ home:rf_control [2021/02/02 05:33]
derek
@@ Line 56: / Line 56: @@
   * Disconnect the serial adaptor from the PC and remove all the wiring
   * Switch the ON/OFF switch on the board back to ''ON'' to enable the RF again
-  * Carefully bend the led panel back into place and fit the board into the case again, screwing it in
+  * Carefully bend the led panel back into place and optionally cut one of the wires to it to disable the relatively bright led
+  * Fit the board into the case again, screwing it in
 ===Create and upload ESPHome firmware===
@@ Line 62: / Line 63: @@
   * Using the ESPHome addon in Home Assistant:
     * Create a new device with the name ''sonoff_rf_bridge'' and any placeholder text for the network info
-    * Enter the code from the [[Notes]] section below into the config of the device
+    * Enter the code from the [[#Notes]] section below into the config of the device
     * ''Save''
     * Three dot menu on the device > ''Compile''
@@ Line 83: / Line 84: @@
   * [[https://tasmota.github.io/docs/devices/Sonoff-RF-Bridge-433/]]
   * [[https://next.esphome.io/components/rf_bridge.html]]
+  * [[https://next.esphome.io/components/cover/time_based.html]]
+  * [[https://next.esphome.io/components/cover/template.html]]
 ====Notes====

Guides