home:rf_control
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Last revision Both sides next revision | ||
|
home:rf_control [2021/01/31 20:06] derek |
home:rf_control [2021/02/01 14:19] derek |
||
|---|---|---|---|
| Line 56: | Line 56: | ||
| * Disconnect the serial adaptor from the PC and remove all the wiring | * Disconnect the serial adaptor from the PC and remove all the wiring | ||
| * Switch the ON/OFF switch on the board back to '' | * Switch the ON/OFF switch on the board back to '' | ||
| - | * Carefully bend the led panel back into place and fit the board into the case again, screwing it in | + | * Carefully bend the led panel back into place and optionally cut one of the wires to it to disable the relatively bright led |
| + | * Fit the board into the case again, screwing it in | ||
| ===Create and upload ESPHome firmware=== | ===Create and upload ESPHome firmware=== | ||
home/rf_control.txt · Last modified: 2021/02/02 05:33 by derek
Page Tools
