This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
home:rf_control [2021/01/31 20:06] derek |
home:rf_control [2021/02/02 05:33] derek |
||
---|---|---|---|
Line 56: | Line 56: | ||
* Disconnect the serial adaptor from the PC and remove all the wiring | * Disconnect the serial adaptor from the PC and remove all the wiring | ||
* Switch the ON/OFF switch on the board back to '' | * Switch the ON/OFF switch on the board back to '' | ||
- | * Carefully bend the led panel back into place and fit the board into the case again, screwing it in | + | * Carefully bend the led panel back into place and optionally cut one of the wires to it to disable the relatively bright led |
+ | * Fit the board into the case again, screwing it in | ||
===Create and upload ESPHome firmware=== | ===Create and upload ESPHome firmware=== | ||
Line 83: | Line 84: | ||
* [[https:// | * [[https:// | ||
* [[https:// | * [[https:// | ||
+ | * [[https:// | ||
+ | * [[https:// | ||
====Notes==== | ====Notes==== |